TM 5-5420-226-20-2
TRANSMISSION OIL COOLER SCREEN REPLACEMENT (sheet 2 of 2)
INSTALLATION :
NOTE
For 2D engine screen, do steps 1,
2, 10, and 11.
1.
Position oil cooler screen (A) into place
on oil cooler.
For 2D engine, install screw (B) and washer (C). For
2.
engine, use socket to install and tighten four screws
and washers(C).
3.
Position harness and bracket (D) into
place on oil cooler.
4.
Using socket, extension, and ratchet
through harness and into bracket,
install two assembled washer screws
(E).
NOTE
You will have bracket (F) and tube
(G) only if your vehicle is equipped
with a 2DA engine.
Position bracket (F) to oil cooler.
5.
Install assembled washer screw (H).
6.
Using socket, tighten screws (B) and (H).
7.
Using 3/4 inch wrench, install bolt (J).
8.
Using socket, extension, ratchet, and 1/2 inch
9.
wrench, install screw (K) and locknut (L) to secure
clamp (M) and tube (G) to bracket (F).
I n s t a l l powerplant (page 5-14).
10.
Install both air cleaner outlet hose
11.
assemblies (page 7-83).
End of Task
Change 2