TM 5-5420-226-20-2
TUBE ASSEMBLY (FUEL INJECTION PUMP INLET TO BULKHEAD ELBOW)
REPLACEMENT (Sheet 4 of 5)
2.
Using fingers, install bulkhead elbow (C)
in hole in front side of engine bulkhead.
3.
Using 3/4 inch wrench to hold bulkhead elbow
(C) and 1 inch wrench intall flat washer (D),
lockwasher (E), and nut (F) on bulkhead
elbow (C).
4.
Using 3/4 inch wrench, turn bulkhead elbow
(C) until alined with hose assembly (G).
Tighten nut (F).
5. Using 1 inch wrench to hold nut (F) and 7/8
inch open end wrench, install tube assembly
(A) on bulkhead elbow (C).
6. Using 7/8 inch wrench, install hose assembly
(G) on bulkhead elbow (C).
Go on to Sheet 5
TA107637
7-32