TM 5-5420-226-20-2
TUBE ASSEMBLY (FUEL INJECTION PUMP INLET TO BULKHEAD ELBOW)
REPLACEMENT (Sheet 5 of 5)
Using fingers, install three new tube clamps
7.
(H) on tube assembly (A).
Using 3/8 inch wrench and flat-tip screwdriver,
8.
install three screws and self-locking nuts (J)
through tube clamps (H).
Install cooling fans (page 9-57).
9.
Install ground hop kit (page 5-25).
10.
Perform powerplant test run (page 5-30).
11.
Disconnect ground hop kit (page 5-40).
12.
Install powerplant (page 5-14).
13.
End of Task
TA107638
7-33