TM 5-5420-226-20-2
TUBE ASSEMBLY (FUEL INJECTION PUMP INLET TO BULKHEAD ELBOW)
REPLACEMENT (Sheet 2 of 5)
NOTE
Use drain pan and rags to catch fuel
in hose and tube assemblies.
REMOVAL:
1. Using 7/8 inch wrench, remove hose assembly
(A) from bulkhead elbow (B).
2. Using 1 inch wrench to hold nut of bulkhead
elbow (B) and 7/8 inch wrench, remove tube
assembly (C) from bulkhead elbow (B).
3. Using 3/4 inch wrench to hold bulkhead
elbow (B) and 1 inch open end wrench, remove
nut, lockwasher and flat washer (D) from
bulkhead elbow (B).
4. Remove bulkhead elbow (B) from engine
bulkhead.
5. Using 3/8 inch wrench and flat-tip screwdriver,
remove three screws and self-locking nuts
(E) from tube clamps (F).
6. Using fingers, remove three tube clamps
(F) from tube assembly (C).
Go on to Sheet 3
