TM 5-5420-226-20-2
AIR CLEANER FILTER ELEMENT CLEANING OR REPLACEMENT (Sheet 4 of 5)
Soak filter element in cleaning solution for 15 to 20 minutes, then gently shake it back
3.
and forth for 2 to 3 minutes to free dirt deposits.
4.
Rinse filter element with cool water (35F to 80F) (2C to 27C) until all traces of dirt
and detergent are removed.
If hose is used to rinse filter element, maximum line pressure of 40 psi should be used.
5.
CAUTION
Make sure filter element is completely dry before using.
Inspect filter element after drying to be sure dust is not
caked inside element.
Air dry at normal room temperature until filter element is completely dry. If circulating
6.
air is used, temperature must not exceed 180F (82C).
7.
After cleaning, inspect filter element for damage to seal or ruptured filter material,
place light inside filter element, and inspect from outside. If ruptured, replace with new
filter element.
Use a clean, damp rag and wipe out filter compartment.
8.
INSTALLATION:
CAUTION
Be careful when installing filter element not to damage
filter seal.
1.
Open door (A).
Install filter element (B) by lowering i
2.
bottom of filter compartment (C).
Slide filter element (B) rearward to se
3.
element in position.
Go on to Sheet 5
Change 2