TM 5-5420-226-20-2
FUEL-WATER SEPARATOR DRAIN LINES REPLACEMENT (Sheet 6 of 6)
Install tee (F) into vise and, using 11/16 inch wrench, install adapter (G) into tee (F).
6.
Remove tee (F) and adapter (G) assembly from vise.
7.
Position tee (F) and adapter (G)
8.
assembly into mounting bracket (H).
Using 11/16 inch wrench to hold
9.
adapter (G), use 11/16 inch wrench
and install lockwasher and nut (J)
onto adapter (G).
Using adjustable wrench, install
10.
drain valve (K) into tee (F).
Position hose assembly (L)
11.
to adapter (G) and elbow (M).
12.
Using 9/16 inch wrench, install
hose assembly (L) to adapter (G)
and elbow (M).
Using 9/16 inch wrench, install
13.
hose assembly (D) to tee (F).
Position clamp (N) onto hose
14.
assembly (L).
15.
Using 9/16 inch wrench, install nut
(P) to secure clamp (N).
Close drain valve (K) by turning
16.
clockwise.
Test fuel-water separator (page 7-230).
17.
18.
Install powerplant (page 5-14).
TA107836
End of Task
L
7-229