TM 5-5420-226-20-2
MANIFOLD HEATER IGNITION COIL AND CABLE REPLACEMENT (Sheet 3 of 3)
INSTALLATION:
Position two clamps (A) onto coil (B).
1.
Position coil (B) and clamps (A) on frame.
2.
Install two screws (C) to secure clamps (A) to
3.
frame. Do not tighten.
4.
Connect cable (D) to coil (B).
5.
Using 7/8 inch wrench, tighten cable (D)
connector.
6.
Using 1/2 inch socket, extension, and
1/2 inch wrench, install two screws (E)
to hold bracket (F) to frame.
Using 7/16 inch socket, install two screws
7.
(G) and clamp (H) to bracket (F).
Route cable (D) over bracket and connect
8.
to spark plug (J).
Using 3/4 inch wrench, tighten cable (D).
9.
10.
Using 1/2 inch socket and extension,
tighten screws (C).
Alining keyway, connect electrical connector (K)
11.
to coil (B).
Using pliers, tighten electrical connector (K).
12.
Perform manifold heater operational check
13.
14.
Install powerplant (page 5-14).
TA107898
End of Task
7-291