TM 5-5420-226-20-2
THROTTLE CONTROL HANDLE ASSEMBLY REPLACEMENT (Sheet 2 of 4)
Using 9/16 inch socket with ratchet,
3.
remove two screws and lockwashers (F).
4.
Using 7/16 inch wrench, remove screw
(G) and lockwasher (H).
5.
Using pliers, remove spring (J) from
bracket (K).
Using hammer, tap segment (L) lightly
6.
to remove segment (L) from shaft (M).
Using pliers, remove cotter pin (N).
7.
Remove flat washer (P) and handle (Q)
8.
from bracket (K).
Using hammer and punch, remove
9.
bushing (R).
Using pliers, remove woodruff key (S)
10.
from shaft .(M).
CLAENING AND INSPECTION:
WARNING
Cleaning agent specified is flam-
mable. Use only in well ventilated
areas. Keep away from flames,
sparks, or heat. Do not smoke
while using. Prevent contact with
eyes, mouth, and/or skin. Wear
rubber gloves when performing
cleaning procedures.
Clean all parts using dry cleaning solvent and clean rags.
1.
Inspect all parts for cracks, bends, wear, and other defects. Replace any defective
2.
parts.
TA108073
Go on to Sheet 3