TM 5-5420-226-20-2
ACCELERATOR LINKAGE BULKHEAD FLANGE REPLACEMEMT (Sheet 3 of 3)
INSTALLATION:
Using vise, press two new seals (A) and new bearings (B) into flange (C), making sure
1.
lips of seals (A) are outward and seals (A) are flush with flange surface.
Push flange (C) onto rod and into position against plate (D).
2.
Using socket with extension, install two nuts (E) and lockwashers (F).
3.
Install nut (G) loosely on rod.
4.
Using wrench, install rod end (H) on rod up to start of chalk mark.
5.
Holding rod end (H) with wrench, use other wrench to tighten nut (G) against rod end (H).
6.
Position clevis (J) on rod end (H).
7.
Install pin (K) through clevis (J) and rod end (H).
8.
Using pliers, install cotter pin (L).
9*
Using cross-tip screwdriver, install six screws (M) securing access plate (N).
10.
TA108071
End of Task