TM 5-5420-226-20-2
LEFT EXHAUST EJECTOR TUBE REPLACEMENT (Sheet 3 of 4)
INSTALLATION:
Position insulation (A and B) to ejector
1.
tube (C).
Using cross-tip screwdriver and 5/16 in
2.
wrench, install 11 screws (D), 22 flat
washers (E), 11 new lockwashers (F), and
11 nuts (G) to secure insulation (A and B)
to ejector tube (C).
Position packing (H) and clamp (J) onto
3.
ejector tube (C). Use flat-tip screwdriver
to tighten clamp (J).
Apply a light coat of silicone compound
4.
to end of two hoses(K).
Position left exhaust ejector tube (C) and
5.
new gasket (L) onto studs of turbosuper-
charger housing (M).
Using 9/16 inch wrench, install six new
6.
self-locking nuts (N) to secure left ex-
haust ejector tube (C) to turbosuper-
charger housing (M).
ENGINE LEFT BANK
Go on to Sheet 4
Change 2