TM 5-5420-226-20-3
SHIFTING CONTROL TO FORWARD INBOARD LINK ASSEMBLY TUBE REPLACEMENT
(Sheet 4 of 5)
ADJUSTMENT:
NOTE
When adjusting rod ends, make certain
that threads on control tubes extend
past the gage opening in the rod end
to ensure a positive grip.
1.
Using two 9/16 inch wrenches and steel tape, adjust rod ends (A) to obtain the same
center-to-center distance between holes as measured and recorded in steps 5 and 6,
REMOVAL.
2.
Using torque wrench and crow foot adapter, tighten nuts (B) against rod ends (A) to 16-
18 lb-ft (23-24 Nm).
Go on to Sheet 5
TA169030
