TM 5-5420-226-20-3
SHIFTING FORWARD OUTBOARD TUBE REPLACEMENT (Sheet 3 of 4)
ADJUSTMENT:
NOTE
When adjusting rod end, make certain
that threads on control tubes extend
past the gage opening in the rod end
to ensure a positive grip.
1.
Using two 9/16 inch wrenches and steel tape, adjust rod end (A) to obtain same center-
to-center distance between holes in rod end (A) and clevis (B) as measured and recorded
in steps 3 and 4, REMOVAL.
2.
Using torque wrench and crow foot adapter, tighten nut (C) against rod end (A) to 16-
18 lb-ft (23-24 Nm).
Go on to Sheet 4
TA169034