TM 5-5420-226-20-3
SHIFT LINKAGE ADJUSTMENT (Sheet 26 of 28)
136.
Using 9/16 inch wrench, adjust shifting rod
bearing end (G) by turning clockwise until
shifting rod (BV) is past hole (BW).
137.
Using 9/16 inch wrench, remove screw (BZ)
and remove shifting rod bearing end (BY)
from clevis (AN).
Using 9/16 inch wrench, install screw (F)
138.
through clevis (H) and shifting rod bearing
end (G).
139.
Holding rod bearing end (G) with 9/16 inch
wrench, use torque wrench and 9/16 inch
crowfoot adapter to tighten jamnut (BT) to
16-18 lb-ft (22-24 Nm).
140.
Using torque wrench and 9/16 inch socket,
tighten screw (F) to 16-18 lb-ft (22-24 Nm).
TA169079
Go on to Sheet 27
11-78
