TM 5-5420-227-24
HOLD-DOWN CYLINDER REPLACEMENT (Sheet 2 of 3)
6.
Using 7/8 inch wrench on adapter (C),
remove adapter and collar (E).
7.
Using adjustable wrench, remove elbow (F)
and its attached parts.
8.
Place protective coverings over all
open hydraulic parts.
Using 15/16 inch wrench, remove four scre
Throw lockwashers (H) away.
10.
Manually slide hold-down cylinder (J) forward and remove from vehicle.
11.
Drain remaining hydraulic fluid from hold-down cylinder (J).
12.
Place hold-down cylinder (J) in a vise.
13.
Using 1-1/2 inch wrench to hold rod (K)
of hold-down cylinder (J), use screwdriver
to remove plug (L).
14.
Remove container and throw away drained
fluid.
15.
Remove hold-down cylinder from vise.
INSTALLATION:
Place hold-down cylinder (A) in a vise.
1.
2.
Manually start plug (B) on rod (C) of
hold-down cylinder (A).
Using 1-1/2 wrench to hold rod (C), use
3.
screwdriver to tighten plug (B).
4.
Remove hold-down cylinder (A) from vise.
TA170471
Go on to Sheet 3
3-249