'TM 5-5420-227-24' by LOGSA

TM 5-5420-227-24

HOLD-DOWN CYLINDER REPLACEMENT (Sheet 1 of 3)

TOOLS:

Ratchet 3/4 in. drive

Flat-tip screwdriver (large)

1-1/2 in. cylinder rod wrench (stowed right fender box)

7/8 in. open end wrench

10 in. adjustable wrench

Vise

13/16 in. combination wrench

15/16 in. socket 3/4 in. drive

SUPPLIES

Container (to catch fluid)

Tags, identification (for hoses)

Protective covers and caps (assorted sizes)

Pipe tape (Item 19, Appendix D)

Lockwashers (4 required)

REFERENCE:

PRELIMINARY

PROCEDURES:

Remove hold-down cylinder armor (page 3-247)

Relieve hydraulic pressure (page 3-65)

REMOVAL:

Tag and mark for identification, hose

assemblies (A and B), adapter (C), and

adapter elbow (D) as follows:

hose assembly (A) mark CV1; and (B)

mark CV2.

Position container to catch hydraulic fluid.

Using 13/16 inch wrench on adapter (C) and

inch wrench on nut of hose assembly (A),

disconnect hose assembly (A).

Using adjustable wrench on elbow (D)

and 7/8 inch wrench on nut of hose

assembly (B), disconnect hose assembly (B).

Put protective covers over ends of hose

assemblies (A and B).

TA170470

Go on to Sheet 2

3-248