TM 5-5420-227-24
HOLDDOWN CYLINDER HOSE GUARD REPLACEMENT (Sheet 2 of 2)
INSTALLATION:
NOTE
Use pipe tape on all male threads before installation. Start tape on second
thread so tape will not enter hydrauIic system.
1. Slide hose guard (A) over two hose
assemblies (B) and (C).
2.
Slip hose guard (A) into position against
holddown cylinder armor (D).
3.
Using socket, install two screws (E) and new
lockwashers (F).
4.
Using wrench, install hose assemblies "CV3"
(C) and "CV4 (B) on manifold (G) as shown.
Close engine right No. 3 grille door (TM-
5.
5-5420-226-10).
End of Task
TA170468
3-246