TM 5-5420-227-24
HOLDDOWN CYLINDER HOSE GUARD REPLACEMENT (Sheet 1 of 2)
7/8 in. open end wrench
TOOLS:
1-1/2 in. socket with 3/4 in. drive
Ratchet with 3/4in. drive
Rags (Item 12, Appendix D)
SUPPLIES:
Protective plugs (4)
Pipe tape (Item 19, Appendix D)
Pencil
Masking tape (Item 18, Appendix D)
Lockwashers (2 required)
REFERENCE:
Open No. 3 grille door (TM 5-5420-226-10)
PRELIMINARY
PROCEDURES:
Cycle hydraulic levers (page 3-65)
REMOVAL:
Using socket, remove two screws (A)
1.
and lockwashers (B) securing hose guard
(C) to vehicle. Throw lockwashers (B)
away.
NOTE
Cap lines and manifold (D) when
disconnected. Use pencil and masking
tape to tag lines for installation.
Using wrench, remove hose assemblies
2.
"CV3" (E) and "CV4 (F) from mani-
fold (D).
Slide hose guard (C) off hose assemblies
3.
(E and F).
TA170467
Go on to Sheet 2
3-245