TM 5-5420-228-24
HOLD-DOWN CYLINDER REPLACEMENT (Sheet 2 of 3)
Using 7/8 inch wrench on adapter (C),
3.
remove adapter (A) and collar (E).
Using adjustable wrench, remove elbow (F)
4.
and its attached parts.
Using 15/ 16 inch wrench, remove four screws (G) and lockwashers (H).
5.
Manually slide hold-down cylinder (J) forward and remove from vehicle.
6.
Drain remaining hydraulic fluid from hold-down cylinder (J).
7.
Place hold-down cylinder (J) in a vise.
8.
Using 1-1/2 inch wrench to hold rod (K)
9.
of hold-down cylinder (J), use screwdriver
to remove plug (L).
10.
Remove hold-down cylinder from vise.
INSTALLATION:
Place hold-down cylinder (A) in a vise.
1.
2.
Manually start plug (B) on rod (C) of
hold-down cylinder (A).
3.
Using 1-1/2 wrench to hold rod (C), use
screwdriver to tighten plug (B).
4.
Remove hold-down cylinder (A) from vise.
TA251645
Go on to Sheet 3
