TM 5-5420-228-24
CLUTCH ASSEMBLY REPLACEMENT AND REPAIR (Sheet 8 of 9)
22.
Using 1/4 inch screw key, loosen setscrew
(N).
23.
Place key (AE) in shaft (AF).
24.
Insert shaft (AF) in clutch assembly (AG)
alining recess in shaft with setscrew (N)
and make sure shaft is seated in bearing.
25.
Using 1/4 inch screw key, tighten set-
screw (N).
26.
Gently pull shaft (AF) to make sure it
is firmly seated, being careful assembly
does not separate.
27.
Manually install gear (AH) and bearing
(AJ) on clutch assembly (AG).
28.
Using arbor press, press ring (AK) on
sleeve (AL).
29.
Using 7/16 inch wrench, install lubrication
fitting (AM) on collar (AN).
Place two halves of collar (AN) on sleeve
30.
(AL).
31.
Manually install two bolts (AP), shims
(AQ), and nuts (AR).
Holding two bolts (AP) with 9/16 inch
32.
wrench, use 9/16 inch wrench to tighten
two nuts (AR).
TA251691
Go on to Sheet 9
4-40
