TM 5-5420-228-24
CLUTCH ASSEMBLY REPLACEMENT AND REPAIR (Sheet 4 of 9)
14.
Remove cover (B).
15.
Remove pin (A) and spring (R).
NOTE
Do steps 16 and 17 only if identification plate
is defective.
16.
Using hammer and chisel, tap out two drive scre
(S). Throw drive screws (S) away.
Remove plate (T) from cover (B).
17.
Using pliers, remove three cotter pins (U). Thro
18.
cotter pins (U) away.
19.
Manually remove three pins (V) from yoke (W).
Separate six levers (X), three springs (Y),
20.
and six pins (z).
Manually remove six springs (AA).
Manually remove three sets of friction linings
(AB), two clutch discs (AC), and hub and back-
plate (AD) from clutch spider assembly (AE).
Using 1/4 inch screw key, remove setscrew (E)
from hub and backplate (AD).
Using hammer and punch, remove six pins (AF).
Go O n to Sheet 5
TA251687
4-36