TM 5-5420-228-24
Section III. Cylinder Rod End Connector and Hydraulic Reservoir
ROD END CONNECTOR REPAIR (Sheet 1 of 1)
TOOLS:
Arbor Press
PRELIMINARY PROCEDURE:
Remove rod end connector (pages 3-225, 3-230.2, 3-234, or page 3-238.2)
DISASSEMBLY:
1.
Place rod end connector (A) in arbor press.
2.
Press out sleeve bearing (B).
ASSEMBLY:
1.
Position sleeve bearing (B) in alinement with hole in clevis of rod end connector (A).
2.
Using arbor press, press sleeve bearing (B) into clevis of rod end connector (A).
3.
Install rod end connector (pages 3-228, 3-230.5, 3-237, or page 3-238.5).
End of Task
