TM5-5420-228-24
RESERVOIR QUADRANT REPLACEMENT (Sheet 3 of 4)
CLEANING:
Using putty knife, remove sealing compound from mating surfaces of reservoir quadrant
1.
and vehicle.
WARNING
Cleaning agent specified is flammable. Use only in well ventilated areas. Keep away
from flames, sparks, or heat. Do not smoke while using. Prevent contact with eyes,
mouth, and/or skin. Wear rubber gloves when performing cleaning procedures.
2.
Clean using rags and dry cleaning solvent.
INSTALLATION:
NOTE
Before installing, use pipe tape on all male
threads. Start tape on second thread so
tape will not enter hydraulic system.
1.
Using putty knife, apply sealant to mating surfaces
of vehicle and reservoir quadrant (A).
2.
Attach sling and lifting device to two handles (B).
Have technician operating hoist slowly lift quadrant (A)
3.
into position over vehicle.
4.
While two technicians guide reservoir
quadrant (A), have technician operating
hoist slowly lower reservoir quadrant (A)
into position on vehicle.
5.
Remove lifting device and sling from two
handles (B).
6.
Using 3/4 inch socket, install seven
screws (C) and lockwashers (D).
Using 1-5/16 inch socket, install four
7.
screws (E) and lockwashers (F).
TA251742
Go on to Sheet 4