TM-5-5420-279-10
WARNING
CRUSH HAZARD. THE CRANE DOES NOT LIFT VERTICALLY. DURING THE DISCONNECTION
PROCESS, ENSURE THAT A PERSON IS PLACED AT THE SIDE OF THE LAUNCHER TO
DIRECT THE CRANE OPERATOR SHOULD THE LIFTING SLING MOVE FROM THE VERTICAL.
IF THE SLING IS NOT MAINTAINED IN THE VERTICAL, THE RAMP WILL SWING WHEN
SEPARATED FROM THE END BEAM CAUSING SEVERE INJURY TO SURROUNDING
PERSONNEL.
CAUTION
If end beam does not release from ramp module stop the lift and lower ramp module onto the
slide frame. Investigate the reason for the non-release of the end beam.
3.10.5.6
Operate the lift and traverse controls on the crane to lift ramp module away from end
beam, leaving the end beam on the end beam adapters fitted to slide frame.
3.10.5.7
Continue to operate the lift and traverse controls on the crane and position the far bank
ramp module at 90 degrees across flatrack V1.
3-85
