TM-5-5420-279-10
Crane - Lubrication
8.9.4.1
The lubrication points on the crane MUST be lubricated every 50 hours:
(1)
The central lubrication point for the rotate gear ring (1).
Figure 8.9 Central Lubrication Point for the Rotate Gear Ring
WARNING
DEATH OR PERSONAL INJURY. THESE LUBRICATION PROCEDURES MUST BE
PERFORMED WITH GREAT CARE OR DEATH OR SERIOUS PERSONAL INJURY COULD
RESULT.
CAUTION
Equipment damage. Crane column bearings should be lubricated with the vehicle engine
and the PTO engaged. Failure to observe this instruction could lead to damage to the
equipment
8.9.4.2
Lubricate with MIL-PRF-10924 G grease unless otherwise indicated.
8.9.4.3
The procedure is as follows:
(1)
Clean the lubrication points thoroughly.
(2)
Grease the lubrication points.
(3)
Rotate the crane column in both directions.
(4)
Apply grease a second time.
