TM-5-5420-279-10
Crane - Sliding Surface Lubrication
8.9.7.1
Sliding surfaces should be inspected at the 50 hour point and lubricated when
required, i.e. difficult to operate or sliding surfaces do not have a complete film of
lubricant present.
8.9.7.2
The following lubrication points fall into this category:
(1)
Stabilizer legs (11).
(2)
Side wear pads (12).
(3)
Jib extension wear pads (13).
Figure 8.12 Sliding Surface Lubrication Points
8.9.7.3
The procedure for both as necessary lubrication points and sliding surface
lubrication is as follows:
(1)
Clean the lubrication points thoroughly.
(2)
Grease the lubrication points.