TM-5-5420-279-10
10.6.3.2
Open the guard plates (4) and remove the pin (3) and release the closing sling (9)
from the pulley assembly.
10.6.3.3
Remove and discard the nut (5) and remove the plain washer (6).
10.6.3.4
Withdraw the pulley shaft (7) complete with pulley (8) and guard plates (4).
10.6.3.5
Remove the pulley (8) and guard plates (4) from the shaft (7).
10.6.4 Service/repair
10.6.4.1
Inspect all components for damage and corrosion.
10.6.4.2
Check pulley (8) is free running on shaft (7).
10.6.4.3
Examine threads on shaft for damage.
10.6.4.4
Replace components as required.
10.6.5 Installation
10.6.5.1
Fit onto shaft (7) one guard plate (4), pulley (8) and second guard plate (4).
10.6.5.2
Locate shaft (7) into bush on the deck unit and secure using plain washer (6) and
new nut (5).
10.6.5.3
Place closing sling against lower half of pulley and fit pin (3).
10.6.5.4
Secure pin (3) using plain washer (2) each side and new split pins (1). Secure split
pins.
