TM-5-5420-279-10
10.8.3 Removal
10.8.3.1
Remove spring pins (1) and washer (2) at the center hinge position.
10.8.3.2
Discard the spring pins.
10.8.3.3
Remove the center hinge pin (3).
10.8.3.4
Remove spring pins (1) and washer (2) at the two outer hinge positions.
10.8.3.5
Discard the spring pins.
10.8.3.6
Remove both headed hinge pins (5) and remove the curb (4).
10.8.4 Service/repair
10.8.4.1
Examine the curb and component parts for damage and corrosion.
10.8.4.2
Examine curb hinge brackets for cracks and corrosion.
10.8.4.3
Replace components as required.
10.8.5 Installation
10.8.5.1
Position the curb (4) in its deployed position with hinge brackets correctly located.
10.8.5.2
Insert the three hinge pins (3 and 5) through the hinge brackets.
NOTE
Headed pins are fitted so that the heads are facing outward from the center of the curb
10.8.5.3
Fit the washers (2) each side of the headless hinge pin and the inside facing side of
the headed pins, secure with new spring pins (1).
