TM-5-5420-279-10
WARNING
CRUSH HAZARD. NEVER USE FINGERS TO PUSH PINS IN OR OUT OF HOLES. SERIOUS
PERSONAL INJURY WILL RESULT IF THIS INSTRUCTION IS NOT OBSERVED.
5
Replace the pivot pin.
6
Replace two the 8 mm screws and the pivot pin retaining plate.
7
Release the crane slings.
8
Replace the far bank support bearing pads in the transportation position.
9
Replace the far bank support transport strap.
10 Stow the far bank support, re-fit the crane pads and stepladder with straps, and
prepare launch vehicle for transport.
11.8.5.1
To remove the tail lift for transport proceed as follows:
NOTE
The numbers on the figures refer to the Sub Paragraph numbers in the procedure.
1
Rotate the tail lift to a horizontal position; remove the crane pads, and
stepladder.
2
Using a forklift truck support the tail lift.
3
Disconnect the handset and replace the dust cap onto the socket. Stow the
handset.
