TM-5-5420-279-10
11.8.6.1
To refit the tail lift after transport proceed as follows:
NOTE
The numbers on the figures refer to the Sub Paragraph numbers in the procedure.
1
Move the tail lift into position using the forklift truck and align the pivot holes.
CRUSH HAZARD.
NEVER USE FINGERS TO PUSH PINS IN OR OUT OF HOLES.
SERIOUS PERSONAL
INJURY WILL RESULT IF THIS INSTRUCTION IS NOT OBSERVED.
2
Insert the swing arm pivot pins on both sides.
3
Insert the swing cylinder pivot pins on both sides.
WARNING
POWER SUPPLY CONNECTION OR DISCONNECTION.
ENSURE HYDRAULIC AND
ELECTRICAL SYSTEMS ARE SWITCHED OFF WHEN CONNECTING OR DISCONNECTING
HYDRAULIC COUPLINGS AND ELECTRICAL CONNECTORS. FAILURE TO HEED THIS
INSTRUCTION COULD LEAD TO SEVERE INJURY TO PERSONNEL.
CAUTION
Equipment damage. Protect open coupling and plugs against the entry of dirt during
transport, contamination or damage to plugs and systems may result.
4
Connect the electrical harness to rear light cluster.
5
Re-attach to the chassis where appropriate.
6
Connect the electrical harness to both the solenoid valves. Re-tighten the center
screws in the plugs. Re-attach to the chassis where appropriate.
