TM-5-5420-279-10
686A810b
Figure 11. 112 T3 Flatrack Plan View of Strapping
11.15.3.1
Install the buffer to flatrack wall/hookbar (see 11.116).
11.15.3.2
Position and centralize a loaded approach ramp frame onto the flatrack. Place a
further three approach ramp frames on top, ensuring that the location pads fit into
the recesses in the posts of the frame below.
11.15.3.3
Fit four transportation straps around and over the top of the stack of approach ramp
frames and tighten using the ratchet. Two straps pass diagonally around the posts
on the upper frame.
11.15.3.4
Position two bridging timbers longitudinally on the edges of the module deck towards
the rear. Place two end beams with their lipped rails facing outwards on these
timbers. Bundle the 12 defile markers into two nesting layers of six. Secure
together using two 1.5-meter cam buckle straps and place the bundle on top of the
end beams.
11.15.3.5
Fit two flatrack BII straps around the end beams and tighten using the ratchets.
11.15.3.6
Place the two anchorage baskets at the rear of the flatrack and secure using three
transportation straps. One strap running across the load from left to right, the
remaining two running diagonally opposite across the anchorage baskets.
11-118
