TM 5-5420-280-10
0001 00
GENERAL INFORMATION (Contd)
PREPARATION FOR STORAGE OR SHIPMENT
Refer to WP 0047 00 for limited storage and shipment instructions. Additional
information can be found in TM 746-10, Marking, Packing, and Shipment of
Supplies and Equipment: General Packaging Instructions for Field Use.
For information on preparing the CBT for storage or shipment, refer to
TM 5-5420-234-14&P.
WARRANTY INFORMATION
The Rapidly Emplaced Bridge (REB) is covered by a warranty. All U.S. Army
customers requiring warranty assistance will initiate direct contact through
respective unit Warranty Coordinators (WARCOs). WARCOs will submit all
warranty claims for non-consumable items, greater than one hundred dollars, to the
General Dynamics Santa Brbara Sistemas (GDSBS) Point of Contact (POC)
identified below. Request all claims be submitted both electronically and
telephonically.
REB warranty coverage applies to the following end item:
M21
RAPIDLY EMPLACED BRIDGE
The REB warranty period of performance provides complete "bumper-to-bumper"
coverage for a period of 13 months. Prior to unit handoff, the REB can be placed into
storage for up to 9 months without a negative impact to the warranty period. The
warranty start date begins at customer handoff, upon the acceptance and signing for
the REB. GDSBS POC is:
General Dynamics Santa Brbara Sistemas GmbH
Customer Service Department
Barbarossastrasse 30
67655 Kaiserslautern, Germany
Phone: (International operator code) +49(0) 631 3616 309
Fax: +49(0) 631 3616 396
Email: service@gdsbs.de
For warranty information covering the CBT, refer to TB 5-5420-234-15, Warranty
Program for the Common Bridge Transporter (CBT).
LIST OF ABBREVIATIONS/ACRONYMS
Refer to the glossary in the back of this manual for a list of
abbreviations/acronyms that appear in this TM. For a list of standard abbreviations,
refer to ASME Y14.38.
QUALITY OF MATERIAL
Material used for replacement, repair, or modification must meet the
requirements of this manual. If quality of material requirements are not stated in
this manual, the material must meet the requirements of the drawings, standards,
specifications, or approved engineering change proposals applicable to the subject
equipment.
0001 00-6
