TM 5-5420-202-20-2
MANIFOLD HEATER FUEL RETURN TUBE ASSEMBLY REPLACEMENT (LEFT AND RIGHT
BANK) (Sheet 1 of 7)
PROCEDURE INDEX
PROCEDURE
PAGE
------
-----
---- ---- ------
. .-- -- -- ___ ---.-- ________ ____ ._ ______ ___
Removal
Cleaning and Inspection
I
Installation
- - - - - - ------ ___
-----_
__
.--
------- .. ______ ____ . .
TOOLS: 5/16 in. combination box and open end wrench
1/2 in. combination box and open end wrench
9/16 in. combination box and open end wrench (2 required)
1/2 in. socket with 1/2 in. drive
8 in. adjustable wrench
Flat-tip screwdriver
Hammer, 2 lb ball peen
Ratchet with 1/2 in. drive
Clean rags (Item 12, Appendix D)
Gloves (Item 69, Appendix D)
SUPPLIES:
Goggles (Item 70, Appendix D)
Sealing compound (Item 27, Appendix D)
Dry cleaning solvent (Item 55, Appendix D)
Container
PERSONNEL: TW O
PRELIMINARY PROCEDURES:
Remove powerplant (page 5-2)
Remove engine shroud (page 9-30)
CAUTION
When removing or installing fuel lines, care must be taken not to
damage fittings and threads or twist or distort fuel lines or hoses.
NOTE
There are two manifold heater fuel return tube assemblies,
one for the left bank and one for the right bank. Removal
and installation procedures for both tube assemblies are
similar. This procedure covers the right bank tube assembly.
Go on to Sheet 2
TA248390