TM
5-5420-202-20-2
ACCELERATOR LINKAGE ADJUSTMENT (Sheet 2 of 6)
ADJUSTMENT:
Check to see that threaded shaft (A) is flush
1.
with inside of clevis (B) at location (C).
If threaded shaft is not flush, continue with
step 2. If threaded shaft is flush, skip steps 2
through 4 and continue with step 5.
Using pliers, remove cotter pin (D) and pin (E)
2.
Using 9/16 inch wrench to hold clevis (B), use
3.
1/2 inch wrench to loosen nut (F) and adjust
clevis (B) so that shaft is flush with clevis.
4.
Using 9/16 inch wrench to hold clevis (B), use
1/2 inch wrench to tighten nut (F).
Insert 1/16 inch diameter pin at location (G)
5.
in rod end bearing (H) to be sure that threads
of tube assembly (J) go into rod end bearing
beyond location (G). If tube assembly is not
inserted beyond location (G), go to steps 6 and
7. If tube assembly is inserted beyond location
(G), go to step 8.
Using 7/16 inch wrench to hold rod end bearing (H)
6.
(on flats) and 1/2 inch wrench to loosen nut (K),
adjust rod end bearing as stated in step 5.
Using 7/16 inch wrench to hold rod end bearing (H)
7.
(on flats), use 1/2 inch wrench to tighten nut (K).
NOTE
Rod end bearing (H) or clevis (B)
may be pulled in order to insert
pin (E).
Insert pin (E) and, using pliers, install cotter
8.
pin (D).
Go on to Sheet 3
7-301