TM
5-5420-202-20-2
ACCELERATOR THROTTLE LINKAGE REPLACEMENT (Sheet 8 of 9)
Install flat washer (V), spring (W), and clamp (X) on rod (Q). Make sure clamp (X) is
18.
on scribe mark on rod (Q).
Using 7/16 inch wrench, install screw (Y) and lockwasher (Z) in clamp (X).
19.
Screw nut (AA) onto rod ((Q).
20.
Screw clevis (AB) to same number of
21.
turns recorded for removal on rod (Q).
22.
Using torque wrench and crowfoot attach-
ment, tighten nut (AA) between 6-8 lb-ft
(8-11 NZm) while holding clevis (AB) with
pliers.
23.
Using 1/2 inch wrench, install nut (AC) on
tube (AD).
24.
Using 7/16 inch wrench, install rod end
(AE) on tube (AD).
Go on to Sheet 9
7-320