TM
5-5420-202-20-2
ACCELERATOR LINKAGE BULKHEAD FLANGE REPLACEMENT (Sheet 2 of 3)
2.
Using pliers, remove cotter pin (C) from
pin (D).
Remove pin (D).
3.
4.
Holding rod end (E) with 7/16 inch wrench, use 1/2 inch wrench to back off nut (F). Use
chalk to mark rod threads as close as possible to rod end.
5.
Using 7/16 inch and 1/2 inch wrench, remove rod end (E) and nut (F) from rod (G).
Using socket with extension, remove two nuts (H) and lockwashers (J) securing flange
6.
(K) to plate (L).
Pull flange (K) off rod.
7.
8.
Using vise, hammer, and punch, drive two seals (M) and bearing (N) out of flange (K).
Go on to Sheet 3
7-325