TM
5-5420-202-20-2
ACCELERATOR LINKAGE BULKHEAD FLANGE REPLACEMENT (Sheet 3 of 3)
INSTALLATION:
Using vise, press two new seals (A) and new bearings (B) into flange (C), making sure
1.
lips of seals (A) are outward and seals (A) are flush with flange surface.
Push flange (C) onto rod and into position against plate (D).
2.
Using socket with extension, install two nuts (E) and lockwashers (F).
3.
Install nut (G) loosely on rod.
4.
Using 7/16 inch wrench, install rod end (H) on rod up to start of chalk mark.
5.
Holding rod end (H) with 7/16 inch wrench, use 1/2 inch wrench to tighten nut (G)
6.
against rod end (H).
7.
Position clevis (J) on rod end (H).
Install pin (K) through clevis (J) and rod end (H).
8.
Using pliers, install cotter pin (L).
9.
10.
Install operator's floor access plate (page 17-8).
End of Task
7-326