TM 5-5420-202-20-2
ENGINE SHROUD REPAIR ON THE ENGINE (Sheet 3 of 5)
Using screwdriver, remove six
9.
screws and lockwashers (J) from
r e t a i n e r (K).
10.
Remove retainer (K) from shroud.
11.
Remove seal (L) from shroud.
12.
Using 9/16 inch socket, remove six screws, washers, and lockwashers (M) holding access
plate (N) to right and left sides of shroud.
13.
Remove access plate (N) with gasket from shroud.
14.
Using putty knife, remove gasket from access plate (N).
Cleaning agent specified is flammable. Use only in well ventilated areas. Keep away
from flames, sparks, or heat. Do not smoke while using. Prevent contact with eyes,
mouth, and/or skin. Wear rubber gloves when performing cleaning procedures
15.
Clean with dry cleaning solvent and rags.
ASSEMBLY:
1.
Using putty knife, apply adhesive
to back side of access plates (A).
2.
Install gaskets (B) to access plates
(A).
Go on to Sheet 4