TM 5-5420-202-20-2
FAN DRIVE OIL SEAL REPLACEMENT (Sheet 3 of 5)
Using hammer and brass drift, drive out oil seal (G) from housing (E) and throw away.
5.
T o prevent personal injury, wear
Dry cleaning solvent P-D-680 is toxic and flammable.
protective goggles and gloves and use only m a well-ventilated area. Avoid contact with skin,
eyes, and clothes and don't breathe vapors. Do not use near open flame or excessive heat. The
flash point for Type #1 Dry Cleaning Solvent is 100F (38C) and for Type #2 is 138F (50C).
If you become dizzy while using cleaning solvent, get fresh air immediately and get medical aid.
If contact with eyes is made, wash your eyes with water and get medical aid immediately.
Clean housing (E) with dry cleaning solvent and rags and remove any dried adhesive
6.
and oil.
INSTALLATION:
Using putty knife, coat sides of replacement oil seal with sealing compound. Use care
1.
to prevent sealing compound from contacting felt part of seal.
Position new oil seal (A) in housing with lip of seal toward gasket surface of oil seal
2.
housing (B).
Go on to Sheet 4