TM 5-5420-202-20-3
BULKHEAD CABLE DISCONNECT (Sheet 1 of 29
TOOLS:
Spanner wrench
Flat-tip screwdriver
9/16 in. socket with 1/2 in. drive
Ratchet with 1/2 in. drive
Lockwashers (11 required)
SUPPLIES:
Remove three ground straps from battery negative ter-
PRELIMINARY PROCEDURES:
minals (page 10-268)
Remove commander's seat (page 17-78)
Remove right bulkhead access cover (page 17-2)
REMOVAL:
QUADRANTS REMOVED
FOR CLARITY
1.
Using 9/16 inch socket
remove seven screws (A) and lockwashers
(B) securing connector cover plate (C)
to bulkhead.
2.
Pull connector plate cover (C) and its
gasket (D) away from bulkhead. Harness
assemblies inside bulkhead will come
with cover plate (C) since they are
attached to it.
NOTE
To remove either of the two middle
connectors on the cover plate, you must
first remove either the top or bottom
connector, as required, to get a spanner
wrench on the desired connector.
3.
Using spanner wrench, disconnect and
remove connector (E) at back side of
cover plate (C).
4.
Using flat-tip screwdriver, remove four
screws (F) and lockwashers (G) securing
corre spending connector (H) and gasket
(J) at front side of cover plate (C).
Go on to Sheet 2