TM 5-5420-202-20-3
DUST DETECTOR HULL INTERMEDIATE LEAD ASSEMBLY REPLACEMENT
(Sheet 2 of 4)
2.
Using slip joint pliers, unthread retaining
nut (C) from shell (D). Slide retaining nut
(C) back along cable.
3.
Slide sleeving (E) back along lead assembly (F).
4.
Slide bushing (G) back along cable.
Remove pin (H) from position "C" of insert (J).
5.
6. Pull lead assembly (F) back through bushing (G) and retaining nut (C).
7.
Using socket, remove four screws (K),
lockwashers (L), and flat washers (M)
securing plate (N) to hull floor.
8.
Remove plate (N) from hull floor.
Using diagonal cutting pliers, cut tie wraps
9.
securing lead assembly (F) along smoke lead.
Disconect lead assembly connector (P) from
10.
short lead (Q) on dust detector warning light
wiring harness.
Remove hull intermediate lead assembly
11.
(F) from vehicle.
Go on to Sheet 3
10-298.9
Change 1