TM 5-5420-202-20-3
DUST DETECTOR WARNING LIGHT HARNESS ASSEMBLY REPLACEMENT (Sheet 1 of 2)
TOOLS:
7/16 in. combination box and open end wrench (2 required)
Pliers, slip joint, plastic jaw insert
Lockwasher (2 required)
SUPPLIES:
PRELIMINARY PROCEDURE: Disconnect three battery ground straps (page 10-268)
REMOVAL:
Disconnect four lead connectors (A) connecting dust detector warning light wiring harness
1.
(B) to front master harness assembly (C) and powerplant warning light harness (D).
2.
Using one 7/16 inch wrench to hold nut (E), use other 7/16 inch wrench to remove screw
(F), lockwashers (G), and nut (E) securing ground leads (H) along side of gage indicator
panel.
Disconnect dust detector warning light harness short lead (J) from hull intermediate lead
3.
assembly (K).
4.
Using pliers, disconnect harness connector (L)
from dust detector warning light box (M).
5.
Go on to Sheet 2
Change 1