TM 5-5420-202-20-3
DUST DETECTOR WARNING LIGHT HARNESS ASSEMBLY REPLACEMENT (Sheet 2 of 2)
INSTALLATION:
1.
Connect harness connector (A) to dust detector warning light box (B).
2.
Connect dust detector warning light short lead (C) to hull intermediate lead assembly (D).
3.
Connect lead connectors 509A and 509L of dust detector warning light wiring harness (E)
to lead connectors 509A and 509L of powerplant warning light harness (F) and front
master harness assembly (G) (four places).
Install screw (H) with lockwasher (J) through bracket (K).
4.
5.
Install ground leads (L), washer (M), and nut (N) onto screw (H). Using one 7/16 inch
wrench to hold screw (H), use another 7/16 inch wrench to tighten nut (N).
6.
Connect three battery ground straps (page 10-268).
7.
Turn on master power in driver's compartment.
8.
Press to test lamp on dust detector warning
light box (B).
A. If light comes on, proceed with task.
B.
If light failed to come on, troubleshoot.
End of Task
Change 1
10-298.13