TM 5-5420-202-20-3
DUST DETECTOR HULL INTERMEDIATE LEAD ASSEMBLY REPLACEMENT
(Sheet 4 of 4)
Insert lead assembly (B) through retaining nut (H) and bushing (J).
3.
4. Install pin (K) into position "C" of insert (L).
5.
Slide bushing (J) against insert (L).
6.
Slide sleeving (M) against bushing (J).
7.
Install retaining nut (H) on shell (N).
8.
Wing slip joint pliers, connect starter cable
connector (G) to bulkhead connector (P).
9. Secure lead assembly (B) to smoke lead with new
tie wraps, as required.
10.
Place plate (Q) in position on hull floor.
11.
Using socket, install four screws (R),
new lockwashers (S), and flat washers (T)
securing plate (Q) to hull floor.
End of Task
Change 1
10-298.11