TM 5-5420-202-20-3
SHIFTING CONTROL BRACKET AND LINK ASSEMBLY REPAIR (Sheet 6 of 11)
NOTE
If bearings (T) are to be
replaced, perform steps 14
and 15.
14. Place lever (R) in vise and using 1/8 inch
punch and hammer, remove bearings (T).
15. Using vise, press two new bearings (T),
one at a time, into lever (R). Bearings
(T) must be flush with outer surface of
lever (R).
INSPECTION:
Inspect bearings, washers,
and grease fitting for
wear or damage. Replace
as necessary.
Go on to Sheet 7
TA249312