TM 5-5420-202-20-3
FINAL DRIVE ADAPTER ASSEMBLY AND OIL SEAL REPLACEMENT (Sheet 2 of 2)
INSTALLATION:
1.
Position seal (A) in vehicle.
2.
Make sure that rubber lip of seal (A)
is toward inside of vehicle hull.
Using hammer (B) and block of wood (C),
3.
tap seal (A) into place.
NOTE
Seal is seated when tapped in as far as it will go.
4.
Make sure that all sand, grit, and accumulated
debris has been removed from the final drive
adapter assembly (D).
Apply grease inside final drive adapter
5.
assembly (D) and on final drive asselmbly
input shaft spline (E).
6.
Using oil, lightly coat outside surface of final
drive adapter assembly (D).
7.
Alining internal splines in final drive adapter
assembly (D) with splines on input shaft (E),
slide final drive adapter assembly (D) onto
input shaft and into seal (A).
8.
Install powerplant (page 5-14).
End of Task
TA249376