TM 5-5420-202-20-3
SU SPEN SI ON T ORSI ON BAR REPLACEM EN T (She e t 1 of 7 )
PROCEDURE INDEX
PAGE
PROCEDURE
Removal
Installation
TOOLS: 3/4 in. deep socket with 1/2 in. drive
Ratchet with 1/2 in. drive
Mallet
Crowbar (or pinch bar)
Rod (or drift pin)
Blocks
15 in. adjustable wrench
36 in. extension bar
Automotive wrench
Slide hammer puller (5573615)
Mechanical puller adapter (12251805)
SPECIAL TOOLS: Socket wrench adapter (Item 28, Chapter 3, Section I)
Roadwheel arm lifter (Item 13, Chapter 3, Section I)
SUPPLIES:
Grease (Item 38, Appendix D)
Block
PERSONNEL: Two
PRELIMINARY PROCEDURES: Remove hub (page 14-15)
NOTE
There are six torsion bars on each
side of vehicle.
REMOVAL:
Go on to Sheet 2
Change 4