TM 5-5420-202-20-3
MECHANICAL TRACK ADJUSTING LINK REPAIR (Sheet 2 of 3)
Using hammer and chisel, cut stakes at three
3.
places (both sides) that hold bearing (E) in eye
end of link (B).
4. Position bearing driver to bearing in link (B).
Using 3/4 inch sliding tee, press bearing out of
link eye.
5.
Inspect parts (A) through (E). Replace them as
necessary.
ASSEMBLY:
1.
Position link (A) so eye end is facing upward.
NOTE
Make sure bearing is evenly
mounted in link eye.
Using bearing driver, carefully press bearing
2.
(B) into eye of link (A).
Go on to Sheet 3