TM 5-5420-202-20-3
MECHANICAL TRACK ADJUSTING LINK REPAIR (Sheet 1 of 3)
TOOLS: 3/4 in. sliding tee
7/16 in. combination box and open end wrench
9/16 in. combination box and open end wrench
Hammer
Chisel
Grease gun
Mounted vise
SPECIAL TOOLS: Bearing driver (Item 30.2, Chapter 3, Section I)
SUPPLIES:
Lube fitting
Rags (Item 65, Appendix D)
Grease (Item 37, Appendix D)
Lockwasher
REFERENCE:
PRELIMINARY
PROCEDURES:
Disconnect track (TM 5-5420-202-10)
Remove compensating idler wheel (page 14-51)
Remove track adjusting link assembly (page 14-59)
DISASSEMBLY:
1. Using 7/16 inch wrench, remove grease fitting (A) from link (B).
2.
Using 9/16 inch wrench, remove bolt (C) and lockwasher (D).
Go on to Sheet 2
14-59