TM 5-5420-202-20-4
INTERIOR RELEASE MECHANISM REPAIR (Sheet 9 of 11)
16.
Insert end of spring (U) through hole in
rear of bracket (E). Install antipilferage
seal.
17.
Using pliers, connect and seat other end
of spring (U) onto connecting pin (V) of
pawl (P).
18.
Move handle (A) forward and rearward
to check for proper operation.
NOTE
Make sure pawl lever (P) snaps down-
ward on forward stroke and engages
cam (J) on rearward stoke. Also, this
check will cause lever (K) to move at
same time as lever (H) when activated.
19.
Insert switch guard (W) up through center
hole of retainer (X) and connect to retainer
(x).
Go on to Sheet 10
TA248694
20-36