TM 5-5420-202-20-4
INTERIOR RELEASE MECHANISM REPAIR (Sheet 5 of 11)
13.
Using 3/32 inch punch and hammer,
drive spring pin (AE) out of shaft (Q).
Throw spring pin (AE) away.
14.
Pull handle (AF) off shaft (Q).
CLEANING AND INSPECTION:
WARNING
Dry cleaning solvent P-D-680 is toxic and flammable To prevent personal injury, wear
protective goggles and gloves and use only in a wall-ventilated area. Avoid contact with skin,
eyes, and clothes and don't breathe vapors. Do not use near openn flame or excessive heat. The
flash point for Type #1 Dry Cleaning Solvent is 100 (38C) and for Type #2 is 138 (50C).
If you become dizzy while using cleaning solvent, get fresh air immediately and get medical aid.
If contact with eyes is made, wash your eyes with water and medical medical aid immediately.
1.
Using dry cleaning solvent, clean
metal parts.
Using cleaning fluid, clean switch
2.
assembly and switch connectors.
Check metal parts for cracks.
3.
4.
Check levers, pins, pawl, and handle
shaft for bends or breaks.
5.
Check brackets for bends, elongated
holes, or damaged points.
Check spring wire for nicks and grooves
6.
at contact points.
7.
Replace all defective parts.
ASSEMBLY:
Push handle (A) onto shaft (B). Aline
1.
spring pin hole of handle (A) with hole
of shaft (B).
2.
Using hammer, install new spring pin
(C) into handle (A) and shaft (B).
Go on to Sheet 6
TA248690